You cannot move dimensions if the move requires a change from a linear to a leadered dimension.© 2014 Autodesk, Inc.Dimensions attached to recovered model sketches can be attached to the recovered sketch from the same model sketch in another view. You cannot move dimensions attached to sketch geometry, or moved to sketch geometry, except dimensions attached to recovered model sketches and 3D sketches.Sheet metal folded views and sheet metal flattened views of the same part.Weldment views with different states, such as preparation and machining.

You cannot move dimensions for the following types of views:.The centerline or center mark must be visible in both the parent and target views. The centerline or center mark can be recovered from work features.

You can move only dimensions attached to model geometry, and center lines or center marks.Removing the break can make the moved dimension visible. If the attachment points are inside the break, the dimension is not visible.

Broken views, if an attachment point is available.

Detail, section, and break-out views if attachment points are found in the view.

Views can be rotated and alignment broken from the parent view.

All orthographic base, projected, and auxiliary views.

You can move dimensions for the following types of views:.

Diametric, radial, and angular dimensions can only be moved to a parallel view. Linear diametric dimensions behave as linear dimensions instead of diametric dimensions, so that a diameter dimension created in the side view of a cylinder can be moved to the top view of the cylinder. Dimension attachment points must be available in the target view. You can move all types of dimensions between views of the same model on one sheet.

Autodesk memento 3 dimensions